Cold bath for muscle recovery

Rocean Bath installation

Step 1: Location Requirements
  • Place the Rocean Bath on a flat surface capable of supporting 600 kg.
  • Keep it 2 meters away from any electrical device.
  • Position the Rocean Bath at least 1 meter from the wall.
  • Allow the cooling unit to stand for 24 hours before turning it on to allow the refrigerant to stabilize.

Note: The black version should be protected from direct sunlight, as it can overheat and accelerate surface aging.
Step 2: Level the feet
  • Make sure the Rocean Bath is leveled. If it isn't, adjust the feet by screwing them in or out.
Step 3: Fill the Rocean Bath
  • Fill the Rocean Bath with a hose.
Recommendation: Use a pre-filter in the hose to prevent limescale deposits, especially in areas with hard water. This will extend the life of the appliance and prevent limescale buildup.
Recommended water level: 20 cm from the top.
Step 4: Connect the Rocean Bain
  • Once the Rocean Bath is filled, plug it into a dedicated 220V/240V outlet.
  • Check if water is flowing from the nozzles.

Recommendation: Use an outlet with an on/off switch.
Step 5: Turn on the Rocean Bath and Set the Temperature
WARNING: Do not turn on the Rocean Bath until it is filled to the required level. Running the pump without water could immediately damage the unit and void your warranty!
  • Once turned on, the screen will illuminate.
  • Press the “Power” button. You will hear the pumps start.
  • After one minute, the water temperature will be displayed.
  • Use the “+” and “-” buttons to set the desired temperature, from 3°C to 40°C.
Note: Once activated, the Rocean Bath will automatically maintain the water temperature within 1 degree of your selected setting.